Subjects under Queensland University of Technology
Document Details

FEA Ansys ADPL Assignment

User Description:
This is a past report form ENB311 Stress Analysis at QUT Brisbane. This assignment received a high mark and is a great reference when writing your report.

Thinkswap Satisfaction Guarantee

Each document purchased on Thinkswap is covered by our Satisfaction Guarantee policy. If you are not satisfied with the quality of any document, or you believe the document was incorrectly described or categorised, Thinkswap will provide a full refund of exchange credits so you can check out another document. For more information please click here.

This student studied:
Claim a Thinkswap Bounty

Do you know if the Subject listed above has changed recently? Click report to earn free Exchange Credits!

Document Information:
9 Pages Essays / Projects > 2 Years old
Share

2 Ex Credits


Document Screenshots:
FEA Ansys ADPL Assignment
Topics this document covers:
Solid mechanics Mechanics Deformation Physics Mechanical engineering Materials science Elasticity Finite element method Strength of materials Stress Yield Structural analysis
This is an Essay / Project

Essays / Projects are typically greater than 5 pages in length and are assessments that have been previously submitted by a student for academic grading.

What are Exchange Credits:

Exchange Credits represent the worth of each document on Thinkswap. In exchange for uploading documents you will receive credits. These can then be used to checkout other documents on Thinkswap.

Topics this document covers:
Solid mechanics Mechanics Deformation Physics Mechanical engineering Materials science Elasticity Finite element method Strength of materials Stress Yield Structural analysis
Sample Text:
The four pinhole geometries at the top of the bracket include a circle, a rectangle, a triangle and a rectangle with corners filleted at a 2mm radius, all of which have an area of approximately 250mm2. A free body diagram of the shelf is shown in Figure 1 below. Forces Fw, FA and FB were calculated under the assumption that acceleration due to gravity is 9.81m/s 2 , and the distance between A and B is 0.4m. The values of these forces are listed along with the material properties of the shelf below in table 1. Table 1: Material properties Material Galvanised Steel Elastic Modulus 200Gpa Poisson’s Ratio 0.29 Density 7870 kg/m3 Volum...
Similar Documents to FEA Ansys ADPL Assignment

Stress, Strain, and Failure Notes

This student studied:
University of New South Wales - CVEN2301 - Mechanics of Solids

These are notes written for the final exam (which was an open book exam). The notes include fully worked solutions from past exam papers.

5 Ex Credits

View Details

PV Lab Report - Open & Closed ended PV (7%)

This student studied:
University of Technology Sydney - 48642 - Strength of Engineering Materials

Open & Closed ended PV (7%). Lab report in relation to biaxial stress in a hydraulic cylinder

2 Ex Credits

View Details

Complete notes for the unit AMME2301

This student studied:
University of Sydney - AMME2301 - Mechanics of Solids 1

Complete set of notes from chapter 1-10 for the course Mechanics of Solids-1 (AMME2301)

5 Ex Credits

View Details

Tensile Testing Laboratory Report

This student studied:
Macquarie University - ENGG100 - Introduction to Engineering

Assessment 4: Tensile Testing Laboratory Report. Outlines the methodology and background information behind tensile testing which was performed in class

2 Ex Credits

View Details